new ptw mag guts

[VTBear]

http://www.rsov.com/index.php?target=pr ... t_id=12214

If I missed this posted already my mistake.

[Skippy]

I grabbed a couple to try and they feed quite well but come covered in lube!

Its taken quite a while to clean it out of the BB "tube"

[Private Paula]

Any other advantages or disadvantages??
Works the regulation of the ammount of BBs good or is it totally crap?
How do they fit into the original Mag housing?

[Mahis]

Took one to try it out.

Pinholes don´t line up and it´s very tight to install in systema case. I tested the capacity pin system with 30 round point. It took 32. If I some day give it another try and finish the installation, I´ll tell more. I´m not that impressed so far.

[Stephens]

Same here. Pin holes dont line up and i had to file the Systema shell to Fit the internals!
I allready contacted Vanaras about it and they only said they work fine for them with all kinds of shell they bought to try (systema original, Mag, China PTW mag, ect, ....) .... So no luck here!

The internals have a much more aggresive angle in the lower part of the mag compared to the original systema internals .... maybe grinding off some mm will do it?

[ChefBenni]

Got 5 of these. 2 over a month ago and 3 a week ago.
All are working pretty well. Was only hard to put it into the original Systema metal case. First pin get pretty easy in but the second one was really hard!
Fits perfect in my self modded pmags. Even better then the original ones.

[Beast 85]

I Purchased 5 of these to fit into P-Mag shells to save removing the internals from my Systema mags (trying to lighten my load out) all 5 mags work as well as the systems internals, fitted the pins on the Vanares internals to 90 rds, i have only good things to say about these internal replacments

beast 85