mur upper question

[xnoelx]

hi everyone
i am going to build another upper for my ptw by using mur upper receiver
before this anyone know bomber or dytac is better?
i heard someone said dytac need some ''minor modification''
is that hard mod.?
and anyone have review of both?
thanks

[lUcIfEr]

The anodizing of the Dytac is better than the bomber...in my opinion.
The Bomber is blue, just like the prime lowers before. Dytac is black, but not matte black like the RS stuff.

[xnoelx]

The anodizing of the Dytac is better than the bomber...in my opinion.
The Bomber is blue, just like the prime lowers before. Dytac is black, but not matte black like the RS stuff.

thanks for reply first
beside outlook, i heard someone said dytac's has to mill some place(he hasn't told me which part)
is that true?
i don't afraid of modification myself...i just afraid some place can't be modification...
thanks..

[lUcIfEr]

No, maybe a little bit of the front where the pivot hole goes in, but no need to use a mil, just file it down a few millimeters. At least few people i know did not have any problems with it.

[xnoelx]

No, maybe a little bit of the front where the pivot hole goes in, but no need to use a mil, just file it down a few millimeters. At least few people i know did not have any problems with it.

thanks mate
i know what should i do now
thanks

[lUcIfEr]

No prob, make sure which version to get. Theres the type A and type B. What handguard are you using?
I say get the type B unless you have specific reasons. The only difference is that the type A is the replica of Gen I mur's, which you need to mod to install some(larue, troy, DD) rails, while type B is the Gen II replica, which you wont have to do anything to fit those rails.