Systema A to Z Motor

ewerything else

Systema A to Z Motor

Postby PaulPulver on Fri Aug 10, 2018 8:45 am

Hello,

I burned the motor out on my G4 A1 Noveske M4 and i purchased the Systema A to Z motor to replace it because i wanted to maintain that high torque that the stock motor had as well as gain some FPS. However when i installed the motor i have not been able to get it to work It will pull the spring back till atleast the point where it can be released by the forward assist but not far enough to cycle i guess. If you guys have any suggestions that would be awesome

Any help will be apprecited.

I didn't find the right solution from the Internet.

References:
http://www.airsoftgiforum.com/viewtopic.php?t=16736
utility management service marketing

Thank you.
PaulPulver
Newbie
 
Posts: 4
Joined: Fri Jul 27, 2018 11:46 am

Return to Off Topic



Who is online

Users browsing this forum: No registered users and 2 guests