07 ECU sockets

All the information that is relevant to MAX Model 2007 or older weapons.

07 ECU sockets

Postby Tactical Pikey on Wed May 29, 2013 1:12 pm

hi guys
got a small problem and could lead to an expensive fix if i get it wrong.

i have an 07 but i needed to change the sector gear.

i did this no problem, however when putting the selector cable and powerboard cable back i don't know which 3 core cable goes to which socket on the ECU

i tried the conventional powerboard to the bottom (as in where the 4 core socket is on the 08+), but the gears just turn as if on full on either semi/full setting

id risk swapping them over but don't want to risj blowing the boards

does anyone have a 07 to confirm which cable goes where

thanks
Tactical Pikey
Newbie
 
Posts: 11
Joined: Mon Nov 28, 2011 11:53 am
Location: Norfolk - UK

Re: 07 ECU sockets

Postby Blackwolf on Wed May 29, 2013 1:49 pm

Hello

The selector cable goes on TOP
The ECU cable (3 wire) goes on the BOTTOM

If you have a spinning of gears when you connect the battery then you have a short circuit or burnt unit in the buffer tube.

Regards

Blackwolf
BLACKWOLF aka Francisco Costa Lobo
www.airsoftmechanix.com
User avatar
Blackwolf
Moderator Group
 
Posts: 993
Joined: Sat Jun 30, 2007 8:08 pm
Location: Portugal

Re: 07 ECU sockets

Postby Tactical Pikey on Wed May 29, 2013 2:07 pm

thanks
it works
Tactical Pikey
Newbie
 
Posts: 11
Joined: Mon Nov 28, 2011 11:53 am
Location: Norfolk - UK

Re: 07 ECU sockets

Postby Blackwolf on Wed May 29, 2013 6:09 pm

Hello

Good job ;)

Regards

Blackwolf
BLACKWOLF aka Francisco Costa Lobo
www.airsoftmechanix.com
User avatar
Blackwolf
Moderator Group
 
Posts: 993
Joined: Sat Jun 30, 2007 8:08 pm
Location: Portugal


Return to Generation MAX Model 2007



Who is online

Users browsing this forum: No registered users and 1 guest

cron